Carriage motor bracket
Pincharm spring retaining bushing
RS-232C serial extension cable - 25-pin (M) to 25-pin (F) - 5.0m (16.4ft) long
Ribbon cable with ferrite - Has 5-pin (F) connectors - 16.5cm (6.5in) long
Power supply cable - Has 12-pin (F) connectors - 39.7cm (15.6in) long
Spindle end cap - Small core spacer - Removes for loading the media roll. Please order spindle assembly.
Ribbon cable clamp (top half) - Secures the trailing cable to the top of the carriage assembly
Ribbon cable clamp (bottom half) - Secures the trailing cable to the top of the carriage assembly
Cutter mechanism assembly - Auto cutter for rollfeed paper
Tubeaxial fan for HP DesignJet 750C Series
High gloss white film (4 mil) - 91.4cm (36in) x 30.5m (100ft) roll
Code ROM SIMM (Firmware) (Ver. A.02.10) - Plugs into socket on the main logic board
Foot assembly (includes casters) - Mounts to the bottom of the plotter stand legs (two used)
Overdrive gear cluster
Clutch / overdrive gear assembly - Includes gear, clutch, retaining clip, and two washers
Cable holder (Small U-Shaped piece on top) - One of two pieces that hold the trailing cable to the main chassis
Housing assembly (on left side)
Hardware kit for printer stand - Includes screwdriver, screws, washers, and media bin retaining clips
Leg assembly - Side support for the plotter - Does NOT include the foot assembly
SYNTHETIC OIL (4oz Plastic Bottle) Front and Rear Slider Rods Synthetic oil - One plastic bottle of 3.5oz / 118.29 ML
16MB SIMM memory module
External JetDirect LAN interface module with EtherTwist (10Base-T) and ThinLAN (10Base-2) connectors
External JetDirect LAN interface module with RJ-45 connector for EtherTwist (10Base-T) or 100VG/802.12 input and three parallel (DB-25) output connectors
External JetDirect LAN interface module with EtherTwist (10Base-T) connector
Carriage drive motor assembly - Includes motor and cable
Paper (X-axis) drive motor (includes helical drive gear - NOTE: motor and gear are only sold as a set
JetDirect 400N modular input/output (MIO) internal print server - Provides 10/100Base-TX or 10Base-2 network connection using RJ45 or BNC connectors
External JetDirect token ring interface module with DB-9 and RJ-45 input connectors and three parallel (DB-25) output connectors
HP JetDirect 500X external token ring print server module - Interfaces up to 3 parallel printers to an ethernet 10Base-T (RJ-45), 10Base2 (BNC), or 100Base-TX (RJ-45) LAN
Compression spring - Installed between pincharm assembly and bushing