Carriage Belt - Drives the carriage assembly - For use with 42-inch plotters
Carriage assembly trailing cable kit - CABLE ONLY - NO LONGER INCLUDES installation instructions trailing cables mounting clips and a ferrite - Cables have 30-pin (M) edge connectors - 2.0m (6.5ft) long - For 42-inch models
Hewlett Packard (HP)Hub spindle black svc cap. Cap supports roll paper spindle takes one on each side. Part number is for one pc.
Printhead carriage assembly - Includes carriage, bushings, pen latches, carriage position sensor, and line sensor
Vacuum fan assembly (OEM LIMITED SUPPLY).
Media deflector holders - For the DesignJet 500/800 printer series
Leg assembly, only one included, not both as shown - Side support for the printer - Does NOT include the foot assembly
Pincharm lift mechanism - Includes cam (a long bar) , cam bushings, pinch arm lever, pinch arm lever bushing
Paper axis motor assembly - Includes cablesPaper axis motor assembly - Includes cables
HP Universal Semi-gloss Photo Paper - 91.4cm (36in) x 30.5m (100ft) roll
Formatter PC board FORMATTER POWER HPGL2 SV - RC EIO WITH PC BOARD HP-GL/2 formatter PC board (Includes C7779-60270 128MB SDRAM 100MHz CL2 and firmware) formatter fits for HP Designjet Plotters fix error: 05:10
Formatter upgrade kit - Adds HP-GL/2 DesignJet 500 800 series GL/2 Card C7772A - Plugs into an EIO card slot. GL-2 AND RTL FORMATTER HP-GL/2 and RTL formatter PC board
FORMATTER POWER HPGL2 SV - RC EIO WITH PC BOARD HP-GL/2 formatter PC board (Includes C7779-60270 128MB SDRAM 100MHz CL2) formatter fits for HP Designjet Plotters fix error: 05:10
FORMATTER POWER HPGL2 SV - RC EIO WITH PC BOARD HP-GL/2 formatter PC board (Includes C7779-60270 128MB SDRAM 100MHz CL2 and firmware) formatter fits for HP Designjet Plotters fix error: 05:10
Front platen kit - Includes platens for both the 24-inch and the 42-inch models
BACK PLATEN 42 inch (SVC) - RCBack platen assembly - Curved cover/guide that is installed below the paper drive roller - For use with 42-inch plotters
Power supply assembly for designJet - Includes power switch. (pwr supply for copier module is Q1278-60072)
Setup printhead kit - Used to prime the ink tubes - Includes 4 setup printheads. Used to remove air and prime the ink system
Drive roller encoder sensor
Service station - Includes wipers, pen caps, and the right hand spittoon - Installed in right side of printer
Hewlett Packard (HP)Hub spindle blue svc cap. Cap supports roll paper, spindle takes one on each side. Part number is for one pc.
Left spittoon assembly - Contains absorbers which hold excess ink from printheads
Trim kit - Includes the front and back trims for the left and right sides - Installed between the main printer chassis and the left or right end covers